![aeon labs z-stick gen5 usbport sticky aeon labs z-stick gen5 usbport sticky](http://jeedom.sigalou-domotique.fr/wp-content/uploads/2019/09/usbinterro.png)
AEON LABS Z STICK GEN5 USBPORT STICKY SERIAL
Using the GUI again, enter "/dev/ttyACM0" into the serial port box.
AEON LABS Z STICK GEN5 USBPORT STICKY INSTALL
10-Using openHAB GUI, install and configure the zwave binding. 9-Download and manually install the openHAB QPKG (newly release 2.0 version) package for QNAP. 6-Search for corresponding serial for Zwave, command: “ls /dev/tty*” 7-You should see “ttyACM0” listed 8-Write down the full directory path, “/dev/ttyACM0” as you will need this information for openHAB zwave binding configuration.
![aeon labs z-stick gen5 usbport sticky aeon labs z-stick gen5 usbport sticky](https://blog.jokielowie.com/wp-content/uploads/2017/10/adding-stick.jpg)
1-SSH into your NAS 2-Install Zwave drive, command: "insmod /usr/local/modules/cdc-acm.ko” (you must have version 4.3 beta installed) 3-Insert USB wave stick to back port of NAS 4-Query usb bus, command: "lsusb" 5-You should see "Bus 001 Device 005: ID 0658:0200 Sigma Designs, Inc.” listed. How do I make the stick visible under lsusb? What firmware version are you currently using and does it work correctly?īocaspbx wrote:For those of you trying to find a similar solution, I was able to get a full automation solution on my NAS working with openHAB. When I connect other devices like mouse, they work properly (and are visible in lsusb output). When the stick is connected to the usb port, it flashes Blue, Yellow and Red (apparently this is normal operation). I've also tried restarting my NAS, it didn't help either. I've tried to first rmmod this module and insmod it again, but this didn't solve the issue. cdc-acm.ko is apparently included in 4.3.3 firmware, when I perform command: "insmod /usr/local/modules/cdc-acm.ko” I get an error "file exists". When I perform command "ls /dev/tty*”, I should see the device “ttyACM0” listed, but it's not there. The output from lsusb remains the same with or without the stick connected. essentials When I connect the stick to one of the USB ports, I should be able to see it by using the lsusb command: "Bus 001 Device 005: ID 0658:0200 Sigma Designs, Inc.”. I've tried to follow steps from this forum and official aeotec docs. Since the stick works under windows, I suspect there is some compatibility issue with the current firmware of QNAP. This stick is properly discovered when connected to my PC under windows 10 and can be used to control z-wave devices (Tested with OpenHab2 on Windows 10). Hello I have an Aeotec by Aeon Labs USB stick G5, which I'm trying to connect to my QNAP TS-253 Pro with 4.